 |
VME64x
10-layer construction
• Assembly with or without P0 connectors
• Characteristic impedance 55 Ohm +/-10%
• Handles for insertion /extraction of the daughter card
• Contact pin and jumper for each signal line
• Access to GND, +3.3 V, +5 V, +12 V, -12 V via fastons
• for 160mm and 220mm deep boards
|
| |
VPX
• Conforms to VITA 46 VPX specifications
• Controlled impedance rigid-flex-rigid design
• Alignment keying headers provided for extender
• 100 Ohm differential pair routing
• Mechanical frame supports 6U, 160mm plug-in card
• Frame has injector/ejector latches for plug-in card
• Signal rate: 3.125 Gb/sec
• +5V on/off switch
• Current monitor on +5V power
• Frame has injector/ejector latches to hold
|
 |
VXS
• Conforms to VITA 41.0 VXS backplane specifications
• Controlled impedance rigid-flex-rigid design
• Alignment keying headers provided for extender and plug-in card
• 100 Ohm differential pair routing
• J1 signals are single-ended signals and run point-to-point across the extender
• Mechanical frame supports 6U, 160mm plug-in card
• Frame has injector/ejector latches for plug-in card
• Signal rate: 3.125 Gb/sec
• +5V on/off switch
• Current monitor on +5V power
• Frame has injector/ejector latches to hold extender securely to chassis
|
 |
CompactPCI
• To test peripheral cPCI boards
• Compliant with PICMG 2.0 CompactPCI Specification Rev.3.0
• cPCI signals from P1 and P2 extended using PCI to PCI Bridge
• Bus frequency: 33MHz (standard) or 66MHz
• All pins from P3, P4 and P5 are routed 1:1
• Signals can be individually switched on/off via SMD switches
• Characteristic impedance 65 Ohm +/-10%
• Handles for insertion/extraction of the daughter card
• Two test points for each signal
• Table in Silkscreen showing the mapping of signals
• Access to GND, +3.3V, +5V, +12V, -12V via fastons
• VI/O voltage selectable between +3.3 and +5V
|
